About this Abstract |
| Meeting |
2027 TMS Annual Meeting & Exhibition
|
| Symposium
|
From Mine to Refinery: An EPD Symposium Honoring Shijie Wang
|
| Presentation Title |
Architected 3D-Printed Ion Exchange Resins for Rare Earth Element Extraction and Separation |
| Author(s) |
Xinbo Yang, Chen Wang, Sophie Morton, Tasnuva Liza |
| On-Site Speaker (Planned) |
Xinbo Yang |
| Abstract Scope |
Conventional ion-exchange resins are typically used as small polymer beads in packed beds. Although this configuration provides a large surface area, it can also lead to diffusion limitations, pressure drop, channeling, and clogging. In this work, we explored 3D-printable ion-exchange resins as a way to combine REE-binding chemistry with a controllable resin structure. Rare earth elements were used as a model system because their similar chemical properties make selective separation difficult. First, an acrylamide-based Poly20 resin series was tested using bastnäsite-derived leach solutions. The REE loading efficiency was relatively low in a concentrated, high-contaminant solution at pH 1.8. After dilution, however, the resin showed higher REE loading and preferential loading of REEs over Fe. We then evaluated a phosphate-containing methacrylate monomer, bis[2-(methacryloyloxy)ethyl] phosphate (BMAEP), together with 1,6-hexanediol dimethacrylate as a control. BMAEP could be printed into solid and lattice structures and showed REE-loading activity without added extractant. Adding di(2-ethylhexyl) phosphoric acid (DEHPA) further improved the loading performance, with the 20 wt% DEHPA formulation providing the best overall result among the tested formulations. Lower pH reduced the total REE loading but increased differences in elemental selectivity. Regeneration was limited at room temperature but improved substantially at elevated temperature, with nearly complete unloading achieved within 1 h at 80 °C. These results demonstrate the feasibility of using 3D-printable ion-exchange resins for REE separation. |
| Proceedings Inclusion? |
Planned: |
| Keywords |
Hydrometallurgy, Process Technology, Additive Manufacturing |