ProgramMaster Logo
Conference Tools for 2017 TMS Annual Meeting & Exhibition
Register as a New User
Submit An Abstract
Propose A Symposium
Presenter/Author Tools
Organizer/Editor Tools
About this Abstract
Meeting 2017 TMS Annual Meeting & Exhibition
Symposium Energy Materials 2017: Energy and Environmental Issues in Materials Manufacturing and Processing
Presentation Title Study on Treatment of Chromium Slag by Metallurgical Sintering Process
Author(s) Qingcai Liu, Fei Meng, Lijun Jiang, Ming Kong, Shan Ren, Guang Hu, Qi Zhao
On-Site Speaker (Planned) Qingcai Liu
Abstract Scope The metallurgical sintering method was employed to process chromium slag (CS) which contains a significant fraction of a leachable Cr(VI). And CS was added into the sinter mixtures with mass fraction of 2%, 4%, 8%, and 10%. The effects of CS on physical strength, metallurgical properties of sinter, and Cr(VI) concentration in sinter were studied. The results showed that the shattering index, tumble index both tend to first increased and then decreased with increasing addition of CS. The physical strength of sinter reached the best when the addition ratio of chromium slag was 2%. With the addition of CS increased from 0% to 10%, the reducibility index of sinter increased from 78.36% to 82.26%, whereas the low temperature reduction degradation index (RDI+3.15mm) decreased from 64.89% to 58.35%. The Cr(VI) concentration in sinters increased from 9.76 to 21.61 μg•g-1, and much lower than Cr(VI) concentration in initial chromium slag (1600 μg•g-1).
Proceedings Inclusion? Planned: Stand-alone book in which only your symposium’s papers would appear (indicate title in comments section below)


A Possible Way for Efficient Utilization of Coal Energy: The Combined Process of Ironmaking with Gasoline Synthesis and Electricity Generation
Approach for Pyrolysis Gas Release Modelling and its Potential for Enhanced Energy Efficiency of Aluminium Remelting Furnaces
C-1: Preparation of Battery-grade Ferrous Oxalate by Screening of Reaction Conditions
C-2: Synthesis and Characterization of Electrodes Made from Banana Peel for Multivalent Batteries
Energy Savings in Aluminium Sand Casting Foundries
Enhanced Thermoelectric ZT Constantan Alloy by Cryorolling
Fluoropolymer Coated Condensing Heat Exchangers for Low-grade Waste Heat Recovery
Green Development is the Future Direction for Chinese Steel Industry
Green Manufacturing Process of Shougang Jingtang Steel Plant
Nitrate and Other Anion Removal from Waste Water Using the Hydroflex Technology
Numerical Approach for the Implementation of the Interaction of Pyrolysis Gases and Combustion Products in an Aluminium Melting Furnace
Prediction and Optimal Scheduling of Byproduct Gases in Steel Mill: Trends and Challenges
Processing Non-Oriented Electrical Steels Using Inclined/Skew Rolling Schemes
Study on Treatment of Chromium Slag by Metallurgical Sintering Process
Sustainability and Applicability of Light Metals Producing Processes
The Combined Cycle Power Plant (CCPP) Used In Energy Conversion of Steel Smelting Production
The Influence of Water Vapour on the Fuming Rate in a Ferromanganese System
The Introduction and Process Optimization Research of Oxygen Blast Furnace Ironmaking Technology
Thermoelectric Properties of La-doped SrTiO3 Materials Prepared by Mechanical Alloying
Waste Energy Recovery Technology of Iron and Steel Industry in China

Questions about ProgramMaster? Contact